User Manual

Commissioning
SmartRadar FlexLine Part No.: 4417.762_Rev07
6 - 62 Service Manual
6.4.9.2 Commands
☛ Select [Read device information], to read the static information from the
radio board.
After executing this command, the static information from the radio
board is read from the radio board and made available in diagnostic
entities. See 6.4.9.3.
☛ Select
[Read dynamic info], to read the dynamic information from the
radio board.
After executing this command, the dynamic information from the radio
board is read from the radio board and made available in diagnostic
entities. See 6.4.9.3.
☛ Select
[Restore Defaults], to remove the security key information from
the radar.
In this way, the radar is disconnect from the wireless network.
NOTE: This command CANNOT be given via Engauge.
CAUTION! With this command all settings on the radio board will
be erased!
6.4.9.3 Diagnostic Information
 SD Card Status
 Connection Status
Display Text Description
SDOK SD card with security key present
NOSD No security key / No SD card / Bad SD card
Display Text Description
NO KEY: No security key information available
Insert a memory card with security information.
MACCONN Intermediate message during connection process
SECCONN
CONNECT
The device is connected to the OneWireless network via 2 multinodes / gateways.
DISCOVR Intermediate message during connection process
NOTCONN The radio is not connected.
Make sure the OneWireless network is operational.
Could also happen if the radar is moved to another network.
SECURNG Intermediate message during connection process
NOREDUN The device is connected to the OneWireless network via 1 multinode / gateway only.
BAD KEY No valid key available.
Could happen if the radar is moved to another network (e.g. from factory to customer/
from workshop to real-life network etcetera).