User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 61
 Signal strength (RSSI = Radio Signal Strength Indicator)
The signal strength is shown in dBm. Below -80 to -85 dBm no reliable
connection is possible.
When there is no redundant wireless connection the secondary RSSI
does not show a relevant value.
 Connection status
In the display of the Smartview the following Connection status
messages can / will be visible:
 SD Status
In the display of the SmartView one out of the following SD card
statuses will be visible:
6.4.9 Radio Board Diagnostic Information and Commands
6.4.9.1 Introduction
Diagnostic information, such as the data in the
[extra information] screen,
and more, can also be read using Engauge (professional version), or
with the [Commissioning] screen of the SmartView.
Additionally, there are 3 commands that can be given to the radio board
on the HCI-1WL module.
Display Text Description
NO KEY: No security key information available
Insert a memory card with security information.
MACCONN Intermediate message during connection process
SECCONN
CONNECT
The device is connected to the OneWireless network via 2 multinodes / gateways.
DISCOVR Intermediate message during connection process
NOTCONN The radio is not connected.
Make sure the OneWireless network is operational.
Could also happen if the radar is moved to another network.
SECURNG Intermediate message during connection process
NOREDUN The device is connected to the OneWireless network via 1 multinode / gateway only.
BAD KEY No valid key available.
Could happen if the radar is moved to another network (e.g. from factory to customer/
from workshop to real-life network etcetera).
Display Text Description
SDOK SD card with security key present
NOSD No security key / No SD card / Bad SD card