User Manual

Commissioning
Part No.: 4417.762_Rev07 SmartRadar FlexLine
Service Manual 6 - 49
The Units Index for the SV can be found on the Other tab. This tab has
a different layout than in a standard transducer block, and is described
hereafter.
Parameter Description
Alarm Test By selecting an alarm level to test - High high, High, Low, or Low low - and pressing
OK, the SmartRadar will perform an Alarm test command.
For detail settings, see 6.4.5.2.4.6.
Alarm Hysteresis This is the alarm hysteresis setting.
For detail settings, see 6.4.5.2.4.6.
Secondary Variable The secondary variable of this transducer block. This Secondary Variable equals the
Secondary Value (SV) of the assigned FlexConn function.
- EU at 100% Not used in the SmartRadar FlexLine
- EU at 0% Not used in the SmartRadar FlexLine