User's Manual

Configuration - Configuring OneWireless infrastructure
Wireless Field Interface Part No.: Rev01
2 - 4 User’s Manual
WARNING! When redundancy is enabled, the primary WDM is assigned
physical ID A and the secondary WDM is assigned physical ID
B. The physical IDs are displayed in the UI during normal
operation. Tagging the physical hardware with matching labels
makes it easy to distinguish the WDMs later.
6. Click Next. The Location Settings page appears.
WARNING!
If you have selected the Redundancy Role as Secondary
in the Wireless Device Manager Settings page, then the
Location Settings page options are disabled.
7. Under Location, select the Country Code.
The country code is used to define any location-specific settings within the
OneWireless Network. For example, radio frequency options are location
dependent and vary depending on the country code setting. After completing
the first time configuration, you cannot modify the Country Code.
8. Under ISA 100 Network ID, type the Network ID.
The ISA100 Network ID is the unique identifier for the network. It must contain a
value between 2 (default) and 65535. After completing the first time configu-
ration, you cannot change the Network ID.
9. Click Next.
The Network Settings page appears.
10. Under Field Device Network (FDN), configure the network settings for the
wireless field device network as follows.
a) Field Device Network IP Address: These settings are used to
configure the wireless field device network Ethernet connection
for the WDM. This is used for communication with FDAP.
WARNING! After completing the initial configuration, you cannot
change the Field Device Network IP Address specified in
the First Time Configuration Wizard.
b) Subnet Mask: A subnet mask identifies the bits of an IP address
that are reserved for the network address. For example, if the IP