User's Manual
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Configuration
- 2.1 Configuring OneWireless infrastructure
- 2.2 Configuring Wireless Field Interface device
- 2.3 Configuring the protocol tunneling
- CHAPTER 3 Firmware Upgrade
- CHAPTER 4 Operations
Configuration - Configuring OneWireless infrastructure
Part No.: Rev01 Wireless Field Interface
User’s Manual 2 - 3
3. On the Wireless Device Manager Configuration page, click Configure
New Wireless Device Manager and click Next.
4. On the Wireless Device Manager Settings page, type the WDM Tag
Name and the Description.
The Tag Name is the unique name that is used to identify the WDM. It can be
up to 16 characters long and must begin with an alphabetic character. Do not
use special characters in the Tag Name; underscore is the only acceptable
character. After completing the initial configuration, you cannot change the
WDM name. The Description can be up to 255 characters long.
5. If you need to configure redundant WDM, then under Redundancy Config-
uration, configure the following:
a) Select Enable redundancy for this Wireless Device Manager check box.
b)
Click the Redundancy Role, as required. You can select either Primary
or
Secondary option depending on the redundancy role.
c) In the Partner PCN IP Address box, type the IP address of the partner
WDM.