User's Manual

Configuration - Configuring OneWireless infrastructure
Wireless Field Interface Part No.: Rev01
2 - 2 User’s Manual
2.1 Configuring OneWireless infrastructure
2.1.1 Configuring WDM using the First Time Configuration Wizard
After installing the WDM, you need to configure the WDM to enable it to
function in the OneWireless Network. The First Time Configuration
Wizard guides you through the initial configuration of the WDM. The
First Time Configuration Wizard appears ONLY when you log on to
the OneWireless user interface for the first time or after the WDM is
deleted (returning to factory defaults).
Considerations
The following are some of the network configuration rules that you must
follow while configuring the network properties.
 FDN and PCN must be on separate subnets.
 FDN IP address must be outside the FDAP IP address range.
 FDN subnet mask must include FDN IP address and FDAP IP
address range.
 Default PCN gateway must be on the same subnet as PCN.
WARNING! If you are performing a migration, skip this section and
proceed with the tasks available in the OneWireless
Migration User’s Guide.
To configure WDM using the First Time Configuration Wizard
1.
Log on to the OneWireless user interface using the default User ID and
Password. The First Time Configuration Wizard appears.
2. On the Welcome page of the First Time Configuration Wizard, click Next.