User's Manual

Operations - Reading the Wireless Field Interface field device information
Wireless Field Interface Part No.: Rev01
4 - 2 User’s Manual
4.1 Reading the Wireless Field Interface field device infor-
mation from SmartView
To read the Wireless Field Interface field device information from
SmartVie.
1. On SmartView, press the UP ARROW and DOWN ARROW simulta-
neously (MENU push buttons) to view the menu items on the display.
2. On the display, scroll to the commands item using the MENU
buttons.
3. Press the LEFT ARROW and RIGHT ARROW (SELECT push
buttons) simultaneously. You are prompted to enter the password.
The default password for SmartView is AAAAAA.
4. Use the MENU push buttons to enter the password and then press
the SELECT push buttons. The list of commands appears.
5. Scroll to select the CAN-1WL FlexConn board name and then press
the SELECT push buttons.
6. Scroll to select board and then press the SELECT push buttons.
7. Scroll to select Read Dev Param then press the SELECT push
buttons.
8. On the display, scroll to the commissioning item using the MENU
buttons.
9. Scroll to select the CAN-1WL FlexConn board name and then press
the SELECT push buttons.
The details available on the SmartView are as follows:
Board Serial No
Network Address
Device revision
CAN-1WL Build
Tx Power Level
Radio Mode
SD Card Status
Key Tx Status
Radio Diag1
Radio Diag2
Device Diag1
Device Diag2
Connected Gauge status
Connected Gauge type