User's Manual

Configuration - Configuring the protocol tunneling
Part No.: Rev01 Wireless Field Interface
User’s Manual 2 - 25
2.3.3 Configure ENRAF Ethernet/UDP interface
You can convert Ethernet/UDP interface by using a Lantronix device or
a serial-to-Ethernet/UDP driver. Following are the high-level tasks to be
performed.
 Install and configure the Lantronix device.
 Assign an IP address to the Lantronix device.
 Configure the Standard Serial Tunnel firmware settings on the
Lantronix device.
 Activate ENRAF Ethernet/UDP interface on the OneWireless user
interface.
For more information, refer to section “Overview of Wireless Field
Interface devices” on page 9.
2.3.3.1 Install and configure the Lantronix device
Install the Lantronix DeviceInstaller software on the Wireless Field
Interface client machine using the documentation and media packaged
with the device. After installing the DeviceInstaller software, assign an
IP address to the Lantronix device.