User's Manual

Configuration - Configuring Wireless Field Interface device
Wireless Field Interface Part No.: Rev01
2 - 16 User’s Manual
Units Index: Specifies the unit of the measurement value. The value
varies according to the sensor type selected for a channel. For
example, the process value of the TII-XR sensor card is displayed as
CH01_AI_1 and the Units Index is set to m.
3. Click Apply.
NOTE:
After applying the changes, the newly configured values
appear under the Scale panel.
To configure Mode
1.
On the Property Panel, expand Mode.
2. In the Target list, select the mode as required.
3. The mode types available are Normal, OOS, and Auto.
4. Click Apply.
2.2.3.2 Add channels to publication groups
Perform the following steps to enable/disable the PV publication
capability of field devices.
To add channels to publication groups
1.
On the Selection Panel, select the Wireless Field Interface device channel.
2. On the Property Panel, expand Input Publication panel.
3. In the Channel drop-down list, select the channels for which data publication
needs to be enabled.
NOTE: To disable data publication, select None in the Channel
list.
4. Click Apply.
2.2.3.3 Remove channels from publication groups
To remove channels from publication groups
1.
On the Selection Panel, select the Wireless Field Interface device channel.
2. On the Property Panel, expand Input Publication.
3. For the channel to be deleted from the publication group, click None in the
Channel drop-down list.
4. Click Apply.