User's Manual
Table Of Contents
- CHAPTER 1 Introduction
- CHAPTER 2 Configuration
- 2.1 Configuring OneWireless infrastructure
- 2.2 Configuring Wireless Field Interface device
- 2.3 Configuring the protocol tunneling
- CHAPTER 3 Firmware Upgrade
- CHAPTER 4 Operations
Configuration - Configuring OneWireless infrastructure
Part No.: Rev01 Wireless Field Interface
User’s Manual 2 - 9
3. Under ISA100 Network Provisioning, in the Over the Air Provisioning
group, select Enabled. The WDM is enabled for over-the-air provisioning
support.
4. Click Apply.
The unprovisioned access points start appearing in the Selection Panel.
You can filter the device list to view only the unprovisioned access points in
the network.
5. On the ribbon bar, in the Filter group, click Device Status > Un-Provi-
sioned.
6. Expand the extended Selection Panel to view the available device
parameters.
7. Select the required access point in the Selection Panel or the map view and
then click Accept on the ribbon bar.