User's Manual

Configuration - Configuring OneWireless infrastructure
Wireless Field Interface Part No.: Rev01
2 - 8 User’s Manual
WARNING! If you are configuring the WDM to use the same
process control network IP address, then the wizard
redirects the Web browser. If you have configured
the WDM using a different PCN IP subnet than the
computer, then you need to reconfigure the network
settings of the computer to access the user interface
using the IP address on the new subnet.
2.1.2 Provision the devices using over-the-air provisioning method
Devices in the OneWireless Network can be provisioned using over-the-
air provisioning method. WDM provisions the access points and the
access points that are enabled to function as provisioning devices can
provision the field devices. To enable over-the-air provisioning
capability, you must enable this feature in the user interface.
Any access point that is in the factory default state, when connected to
the OneWireless Network can join the network as an unprovisioned
device. In this state, the WDM contains only the basic details about the
device such as the Tag Name, EUI64, and Radio Revision. Also, there
is no active data communication between the WDM and the device in
the unprovisioned state. You can accept or reject an unprovisioned
device using the user interface. If accepted, the WDM sends the
provisioning data to the device and the device transitions to provisioning
state. A device with the new security data sends join request to the
WDM.
To provision the access points using over-the-air provisioning method
1.
On the Selection Panel, select the WDM.
2. On the Property Panel, expand System Manager.