User's Manual

Configuration - Configuring OneWireless infrastructure
Wireless Field Interface Part No.: Rev01
2 - 6 User’s Manual
WARNING! The network time settings configuration is disabled on the
secondary WDM. Upon synchronization, the secondary
WDM syncs time from primary over the FDN interface.
WARNING! Network time settings configuration is disabled on the
secondary WDM. Upon synchronization, the secondary
WDM syncs time from primary over the FDN interface.
13. Click Use NTPServer or Use System Time, as required.
You can use either the NTP server or system time to configure the network
time of the OneWireless Network.
NOTE: By default, the network time is configured as the
system time. Consider the following while configuring
an external NTP server.
NTP server should be on the PCN or FDN.
NTP server IP address must be within FDN or PCN subnet unless a
default gateway has been configured on the PCN subnet and the
NTP server is accessible through the default gateway.
NTP server IP address should not overlap with the FDN and PCN IP
addresses.
NTP server IP address should not overlap with FDAP IP address
range, if DHCP Server is enabled.
14. If you are selecting NTP server, enter the NTP Server IP Address and click
Next. The Administrator Information page appears.
15. Type the user name and password in the Administrator Name, New
Password, and Confirm Password fields.
The default user name configured for the WDM is administrator. You
can change the default user name in the First Time Configuration
Wizard, if required. However, you cannot change the user name after
completing the initial configuration.
The password must contain at least one character and can contain up
to 32 characters. It should not start or end with a space and must not
contain single quote (‘).