User's Manual
Table Of Contents
- Preface
- Table of contents
- 1 Introduction
- 2 Safety
- 3 Commissioning
- 4 Service and troubleshooting
- Appendix A Article and part numbers
- Appendix B ASCII table
- Appendix C PCB layout
- Appendix D Related documents
- Index
Tank zero
AB
Radar reference
RL
H02 antenna
Radar reference
Radar reference
Radar reference
Radar reference
H04 antenna
OR
SF
PR
AU
Maximum
Safe fill height
Level
Commissioning
Page 20
Figure 3.4 Level start-up tank parameters
3.4.2 Level start-up
Refer to figure 3.4 for level start-up tank parameters.
To get the level from the gauge without any compensation enabled, only the following items should be
programmed.
Radar reference:
The radar reference (zero point for the radar gauge measurement) for the RoD antenna and the planar
antenna’s is the roof nozzle position (refer to figure 3.4).
For the H04 antenna, the radar reference point is located at the flange of the tank separator.
For the H02 antenna, the radar reference point is located at the top of the antenna/tank separator flange.
If the 973 SmartRadar LT is equipped with a stilling well antenna model, item
BD
should be programmed. In
all other cases skip this item and start from item
OM
.