Use and Care Manual

Step 3: Line up the D-shaped
hole in the knob with the
D-shaped shaft. Push the
knob straight onto the shafts
until they stop moving. Set
the product upside down and
rotate the gas pipe assembly
90 degrees as shown in the
picture.
Step 6: Put on lava rock
Step 7: Secure the gas
cylinder. Connect the Gas
Pipe and compression
release valve assembly to
the Propane Gas Cylinder.
Step 8: Connect and secure the other end of
the Gas Pipe and compression release valve
assembly to the gas pipe under the table.
Step 5: Flip back upright and
fit the gas tube into the hole
in the table. Under the table
attach and tighten the nut
onto the gas pipe.
Step 4: Use a Phillips head
screwdriver and set the four
screws M5*12 as shown in
the image.
10 11
PATIOJOY PATIOJOY