Instructions / Assembly

ASSEMBLY INSTRUCTIONS
honey-can-do international 5750 McDermott Drive, Berkeley, IL 60163 USA tele 877.242.2636 www.honeycando.com
(QTY) DESCRIPTION ILLUSTRATIONPART
LIMITED LIFETIME WARRANTY
This product is warranted to be free of defects in material and workmanship for as long as the consumer owns the product. At Honey-Can-Do’s option, defective product will be
repaired, replaced or substituted with a product of equal value. For warranty service, e-mail Honey-Can-Do at [e-mail] or call at [phone]. You may also
contact Honey-Can-Do at 5750 McDermott Drive, Berkeley, IL 60163. Do not dispose of the defective item until or unless you are specifically asked to do so by Honey-Can-Do as we
may require return of the defective item. Honey-Can-Do shall in no event be liable for any incidental or consequential damages. Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above exclusion may not apply to you. This warranty gives you specific legal rights, and you may also have additional rights, which may
vary from state to state.
rolling
utility cart
DIMENSIONS
ITEM #
CRT-01511
37.55"H x 18.5"W x 14"D (95.3 cm x 47.3 cm x 35.6 cm)
©2009 honey-can-do international, llc | all rights reserved
cotter clip goes
inside frame tube
For assistance, please contact us at [e-mail] or 877.2.I.Can.Do.
INSTRUCTIONS
Thank you for purchasing our rolling utility cart. Please follow these
step-by-step instructions. Please plan to spend about 15 minutes
assembling your new utility cart.
1. Slide axle (B) through hole on vertical bar of frame.
Slip cotter clips (E) into hole in axle (B). *Note hole aligns with tube of
frame. You must insert cotter clip (E) inside frame tubing. (see inset 1)
2. Place a washer (C), spring (D) and another washer (C) over axle.
Push wheel (G) on the axle and compress spring.
3. Holding wheel (G) in place put hub cap (I) on the end of axle making
sure holes in hub cap (I) line up with holes in axle (B). Insert cotter pin
(F) in the outer holes on axle.
4. Bend ends of cotter pin (F) using pliers (not provided) to lock
wheel in place. Repeat steps 2, 3, and 4 for other side.
F
(1) frame
(2) wheels
(4) washers
(2) spring
G
H
I
(2) cotters clip
(2) cotters pins
(2) hub caps
(1) axle
(1) plastic latch
G
F
H
H
D
view from
end of axle
Inset 1
tube frame