Manual
Table Of Contents
- COVER
- INTRODUCTION
- A FEW WORDS ABOUT SAFETY
- CONTENTS
- OUTBOARD MOTOR SAFETY
- CONTROLS AND FEATURES
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR OUTBOARD MOTOR
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- TOOL KIT AND OWNER'S MANUAL
- EMERGENCY STARTER ROPE
- MAINTENANCE SCHEDULE
- TRIM TAB ADJUSTMENT
- MANUAL RELIEF VALVE
- ENGINE COVER REMOVAL AND INSTALLATION
- REFUELING
- FUEL RECOMMENDATIONS
- WATER SEPARATOR INSPECTION AND SERVICE
- FUEL FILTER INSPECTION AND REPLACEMENT
- PORTABLE FUEL TANK AND TANK FILTER CLEANING
- ANODE REPLACEMENT
- PROPELLER REPLACEMENT
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL AND CONSUMER INFORMATION
- INDEX
92
Lubrication Points
SERVICING YOUR OUTBOARD MOTOR
THROTTLE ROD/LINK
TILT BRACKET
SWIVEL CASEPROPELLER SHAFT
TILT SHAFT
THRUST RECEIVER
TILLER HANDLE
(LHT type)
THROTTLE ARM/
LINK/PIVOT/PLATE
Apply anticorrosion oil to pivot
surf aces where grease cannot penetrate.
Apply Honda Marine Corrosion Inhibitor (or equivalent) to all areas under the engine cover and any exposed metal
surfaces except the belts.
Lubrication interval:
After the first 20 hours or 1 month, then
every 100 hours or 6 months (refer to
the maintenance schedule on page ).
Apply Honda Marine waterproof grease
to the parts shown below:
81
08/08/04 18:52:31 31ZY9600_093