Manual
Table Of Contents
- COVER
- INTRODUCTION
- A FEW WORDS ABOUT SAFETY
- CONTENTS
- OUTBOARD MOTOR SAFETY
- CONTROLS AND FEATURES
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR OUTBOARD MOTOR
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- TOOL KIT AND OWNER'S MANUAL
- EMERGENCY STARTER ROPE
- MAINTENANCE SCHEDULE
- TRIM TAB ADJUSTMENT
- MANUAL RELIEF VALVE
- ENGINE COVER REMOVAL AND INSTALLATION
- REFUELING
- FUEL RECOMMENDATIONS
- WATER SEPARATOR INSPECTION AND SERVICE
- FUEL FILTER INSPECTION AND REPLACEMENT
- PORTABLE FUEL TANK AND TANK FILTER CLEANING
- ANODE REPLACEMENT
- PROPELLER REPLACEMENT
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL AND CONSUMER INFORMATION
- INDEX
×
−
−
×
−
−
90
SERVICING YOUR OUTBOARD MOTOR
CONNECTOR
LOCK TAB
IGNITION
COIL
PLUG WRENCH
BOX WRENCH
SEALING WASHER
INSULATOR
625mm
FLANGE BOLT
0.039 0.051 in
(1.0 1.3 mm)
Remove the 6 25 mm flange
bolt.
Disconnect the connector by
pushing the lock tab and remove
the ignition coil.
Remove the spark plug using the
plug wrench, box wrench and the
Phillips /flat-tip screwdrivers
(accessories).
Inspect the spark plugs. Replace
them if the electrodes are worn, or
if the insulators are cracked or
chipped.
Measure the spark plug electrode
gap with a wire-type feeler gauge.
The gap should be 0.039 0.051
inches (1.0 1.3 mm). If the gap
is out of the specification, replace
the plug with a new one. Never try
to readjust the gap.
5. 6.
7.
4.
08/08/04 18:52:12 31ZY9600_091