Manual
Table Of Contents
- COVER
- INTRODUCTION
- A FEW WORDS ABOUT SAFETY
- CONTENTS
- OUTBOARD MOTOR SAFETY
- CONTROLS AND FEATURES
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR OUTBOARD MOTOR
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- TOOL KIT AND OWNER'S MANUAL
- EMERGENCY STARTER ROPE
- MAINTENANCE SCHEDULE
- TRIM TAB ADJUSTMENT
- MANUAL RELIEF VALVE
- ENGINE COVER REMOVAL AND INSTALLATION
- REFUELING
- FUEL RECOMMENDATIONS
- WATER SEPARATOR INSPECTION AND SERVICE
- FUEL FILTER INSPECTION AND REPLACEMENT
- PORTABLE FUEL TANK AND TANK FILTER CLEANING
- ANODE REPLACEMENT
- PROPELLER REPLACEMENT
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL AND CONSUMER INFORMATION
- INDEX
66
STOPPING THE ENGINE
Emergency Engine Stopping
OPERATION
PULL
LANYARD
LANYARD
PULL
CONTROL PANEL
LANYARD
PULL
EMERGENCY STOP
SWITCH CLIP
EMERGENCY STOP SWITCH
EMERGENCY STOP SWITCH
EMERGENCY STOP
SWITCH CLIP
EMERGENCY STOP SWITCH CLIP
EMERGENCY
STOP SWITCH
LHT Type (tiller handle)
Side-Mount Type
LRTandXRTTypes
(remote control)
Panel-Mount/Top-Mount Types
To stop the engine in an emergency,
pull the emergency stop switch clip
out of the emergency stop switch by
pulling the emergency stop switch
lanyard.
Turn the ignition switch key to the
OFF position after verifying the
emergency stop switch operation.
We suggest that you stop the engine
this way occasionally to verify that
the emergency stop switch is
operating properly.
08/08/04 18:48:33 31ZY9600_067