Use and Care Manual

OPERATION

3. Start the engine on each generator and make sure each OUTPUT

indicator (green) comes ON.

4. Turn the AC circuit protector of the parallel operation box ON.

5. Plug in the appliance following the instructions provided with the

parallel kit.

6. Turn on the appliance.

If the generators are overloaded (see page 46), or if there is a short

circuit in a connected appliance, the OVERLOAD indicators (red) will

come ON. The OVERLOAD indicators (red) will stay ON and after

about five seconds, current to the connected appliance(s) will shut off,

and the OUTPUT indicators (green) will go OFF. Stop both engines

and investigate the problem.

Determine if the cause is a short circuit in a connected appliance or an

overload. Correct the problem and restart the generators.

AC CIRCUIT PROTECTORS

RECEPTACLE

31Z376160.book 44 ページ２０１９年２月８日　金曜日　午後２時２分