Operation Manual

CORDLESS LAWN TRIMMER — HHTE38BE28 EN
EN
19
11 cm
Tab
18
20
Wind Direction
Wind the spool with new line
WARNING: To prevent serious personal injury, remove the battery pack from
the tool before servicing, cleaning, changing attachments or removing material from
the unit.
1. Press the release tabs on the spool
base and remove the spool retainer by
pulling it straight out (Fig. 18).
2. Remove the spool. Use a clean cloth
to clean the inner surface of the spool
retainer and spool base.
NOTICE: Always clean the spool retainer,
spool and spool base before reassembling
the Lawn Trimmer head.
3. Check the spool retainer, spool and
spool base for wear. If necessary,
replace the worn parts.
4. Take approximately 6 m of new cutting
line. Fold the line in half and then adjust
it so that one end is 11 cm longer than
the other end (Fig. 19).
5. Hook the folded end of the cutting line
onto either of the slots in the spool
(Fig. 20).
6. Wind the line, in two even and tight
layers, onto the spool. Wind the line
in the direction indicated on the spool
(Fig. 20).