Operation Manual

CORDLESS LAWN TRIMMER — HHTE38BE
27 EN
EN
ADJUSTING CUTTING LINE LENGTH
The bump head allows the operator to
release more cutting line without stopping
the motor. As line becomes frayed or
worn, additional line can be released
by lightly tapping the bump knob on the
ground while operating the Lawn Trimmer
(Fig. 17).
NOTICE: Always keep the cutting line
fully extended. Line release becomes
more difcult as the cutting line becomes shorter.
WARNING: Do not remove or alter the line cutting blade assembly. Excessive
line length will cause the motor to overheat and may result in serious personal injury.
For best results, tap the bump knob on bare ground or hard soil. If line release is
attempted in tall grass, the motor may overheat. Always keep the cutting line fully
extended. Line release becomes more difcult as the cutting line becomes shorter.
LINE REPLACEMENT
NOTICE:
Always use Original Honda 2.4 mm diameter nylon cutting line. Using
line other than that specied may cause the Lawn Trimmer to overheat or become
damaged.
WARNING: Never use metal-reinforced line, wire, rope, etc. These can break
off and become dangerous projectiles.
There are two methods to replace the cutting line:
1. Wind the spool with new line.
2. Install a pre-wound spool.
Bump Knob
17