Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
40
SERVICING YOUR TILLER
CLUTCH CABLE ADJUSTMENT
1. Set the handlebar height in the center position (see page 21).
2. Measure the spring lengths when the clutch lever is operated to the
DISENGAGED and ENGAGED positions.
3. With the clutch lever ENGAGED, adjust so that the extension value
of the clutch spring is as measured below.
Extension value:
A (ENGAGED) - a (DISENGAGED) = 0.08 ± 0.02 in (2 ± 0.5 mm)
4. Loosen the lock nut and turn the adjusting nut to obtain the correct
extension value of the clutch spring. After adjustment, tighten the
lock nut securely.
Release
(DISENGAGED)
Squeeze
(ENGAGED)
CLUTCH SPRING
<Main clutch lever DISENGAGED>
<Main clutch lever ENGAGED>
A
a
ADJUSTING NUT
LOCK NUT
INCREASE
EXTENSION
VALU E
DECREASE
EXTENSION
VALU E
31V146410.book 40 ページ ２０１８年３月７日 水曜日 午前９時８分