Replacement Part List
Table Of Contents
- F220
- INTRODUCTION
- CONTENTS
- TILLER SAFETY
- COMPONENT & CONTROL LOCATIONS
- BEFORE OPERATION
- OPERATION
- SERVICING YOUR TILLER
- THE IMPORTANCE OF MAINTENANCE
- MAINTENANCE SAFETY
- MAINTENANCE SCHEDULE
- REFUELING
- FUEL RECOMMENDATIONS
- ENGINE OIL LEVEL CHECK
- ENGINE OIL CHANGE
- ENGINE OIL RECOMMENDATIONS
- TRANSMISSION OIL LEVEL CHECK (USA model)
- AIR FILTER INSPECTION
- AIR FILTER CLEANING
- SPARK PLUG SERVICE
- CLUTCH CABLE ADJUSTMENT
- THROTTLE CABLE ADJUSTMENT
- SPARK ARRESTER SERVICE (optional part)
- STORAGE
- TRANSPORTING
- TAKING CARE OF UNEXPECTED PROBLEMS
- TECHNICAL INFORMATION
- CONSUMER INFORMATION
- QUICK REFERENCE INFORMATION
33
SERVICING YOUR TILLER
TRANSMISSION OIL LEVEL CHECK (USA model)
Check the transmission oil level with the tiller on a level surface and
the engine stopped.
Make sure the area around the oil level check bolt is clean.
1. Remove the transmission oil level check bolt and sealing washer.
Check the oil level. The oil should be level with the lower edge of the
oil filler hole.
If the transmission oil level is low, add the recommended oil by the
following procedure.
Disassembly
2. Move the choke lever to the CLOSED position.
If you try to remove the fan cover with the choke lever in the OPEN
position, the choke rod may not come out of the choke rod hole, and
the choke mechanism may be damaged.
TRANSMISSION OIL
LEVEL CHECK BOLT
UPPER LIMIT
(Lower edge of
the oil filter hole.)
SEALING WASHER
(Replace)
31V146410.book 33 ページ ２０１８年３月７日 水曜日 午前９時８分