Owner's Manual

5. Turn the engine switch on the remote control switch box to the ON
position.
When the engine switch is turned to the ON position, the glow light in
the starter button will light for about 4 seconds. Wait for the glow light
to go out before starting the engine.
ENGINE SWITCH
STARTER SUTTON (with glow light)
6. Push and hold the starte button until the engine starts.
The pilot light comes on after the engine starts.
l-EiEq op
erating the starter motor
for more than 5 seconds can
damage the motor. if the engine fails to start, release the switch and wait
10 seconds before operating the starter again.
Generator Use
For operation of the generator, refer to page 19-22.
59