Operation Manual

Removing & Installing Body Components u Battery
60
Maintenance
Battery
❙
Removal
Make sure the ignition switch is off.
1. Remove the front seat. 2 P. 57
2. Unhook the rubber strap from rear side.
3. Disconnect the negative - terminal from
the battery.
4. Disconnect the positive + terminal from
the battery.
5. Remove the battery taking care not to
drop the terminal nuts.
❙
Installation
Install the parts in the reverse order of
removal. Always connect the positive
+
terminal first. Make sure that bolts and nuts
are tight.
Readjust the clock after the battery is
reconnected since the clock goes wrong
once the battery disconnected.
The tripmeter A and B will be reset if the
battery is disconnected.
For proper handling of the battery, see
“Maintenance Fundamentals.”
2 P. 46
“Battery Goes Dead.”
2 P. 94
Rubber
strap
Battery
Positive
terminal
Negative
terminal
13 CBR500R-32MGZB000.book 60 ページ ２０１２年１２月１２日 水曜日 午後３時４７分