Owner's Manual

Servicing Your Honda
164
Engine Oil & Filter
3. Stop the flushing.
Avoid running the engine without water flow
for more than 15 seconds to prevent severe
engine and exhaust system damage.
4. Stop the engine and wait a few minutes.
5. Remove both seats (page 153).
This procedure continues with Step 6 on page
165.
To check the oil level on calm water
1. Start the engine.
2. Warm up the engine at approximately 4,000
rpm for 5 minutes.
If the air temperature is below 10°C (50°F),
let the engine idle for an additional 5
minutes (a total of 10 minutes).
3. Let the engine idle for a minute.
4. Stop the engine and get off your PWC.
5. Remove both seats (page 153).
NOTICE