user manual

Now locate the over flow hose’s from the carb. At the engine case there is a metal rod that holds
them in place.
Remove the screw and rod, as that’s where the starter bolts to the case.
From the flywheel side slide the starter and align with the screw hole that you removed the rod from.
From your pile of old case bolts find a screw about 35 mm (1.25) or so and reinstall the metal rod on
top of the screw. Unless you are good at guessing the alignment of the starter in relation to the case
do not Locktite and tighten, as you’ll be removing later to do so.
Run the wire up to the air box area.
5