Automobile Accessories User Manual

12 of 15 AII 37561-38377 (0711) © 2007 American Honda Motor Co., Inc. – All Rights Reserved.
34. While wearing eye protection drill the rear bumper:
NOTE: Center sensors are 26 mm holes, side sensors are
24 mm holes.
• From the outside of the bumper, drill all eight
pierced marks using a 3 mm drill bit.
• Using a 24 mm hole saw, enlarge the lower
outboard hole on the left side of the bumper.
Remove all burrs.
• Using a 24 mm hole saw, enlarge the upper
outboard hole on the left side of the bumper.
Remove all burrs.
771104AB
REAR BUMPER
BURRS
(Remove.)
DRILL
(3 mm
DRILL BIT)
24 mm
HOLE SAW
LOWER
HOLE
HOLE
771105AB
REAR BUMPER
DRILL
24 mm
HOLE SAW
DRILL
3 mm
DRILL BIT
HOLE
UPPER HOLE
BURRS
(Remove.)
• Using 26 mm holes saw, enlarge both lower in
board bumper holes at the center of the bumper.
Remove all burrs.
35. Install the two corner sensors into the 24 mm holes
in the rear bumper using the sensor clips. Not the
direction and the pin location for each sensor.
771106AB
DRILL
(26 mm
HOLE SAW)
HOLE
LOWER
HOLE
DRILL
(3 mm
DRILL BIT)
REAR BUMPER
BURRS
(Remove.)
742412AE
REAR
BUMPER
REAR
BUMPER
CORNER
SENSOR
(White)
SENSOR
CLIP
24 mm HOLE
CORNER
SENSOR
(White)
CORNER
SENSOR
(White)
REAR
BUMPER
24 mm
HOLE
CORNER
SENSOR
(White)
Inside
Outside
SENSOR
CLIP
Inside
Outside
www.collegehillshonda.com