User's Manual

3/27
All product specifications are subject to change without notice
2. HW installation guide and specifications
This section describes HW overview of the Outdoor Small Cell-T99B226
Connectors and Interfaces
As shown below in fig 2.1, T99B226 consists of four N-type cable connectors (LTE antenna
#1,2,3,4) on the bottom side of the device for LTE antennas and an ethernet RJ45 port for power.
There are four bolt holes on the back side of the device so that it can be pole mounted onto a
factory pole by using a mounting bracket. The SMA connector on the back side of the device can
be used to connect to GPS antenna and provide 3.3V DC power to it.
Figure 2.1 T99B226 Ports and Connectors
LTE Antenna #1 (Ant2-Main)
LTE Antenna #2 (Ant2-Div)
RJ45
GPS Antenna
LTE Antenna #3 (Ant1-Main)
LTE Antenna #4 (Ant1-Div)
Vent valve
Bracket screw