User's Manual

26/27
All product specifications are subject to change without notice
RF detection failed
To check and try following step:
1. 1. Try manually power cycle HeNB
2. After step1 for 3 times, if the situation still exist, call service center, and replace the HeNB
Ethernet interface link down
To check and try following step:
1. Please check if ethernet cable on HeNB side or uplink router side is loose
2. Change another ethernet cable
3. Checking Home Router Settings.
4. Checking SBM Networking Settings.
5. Replace HeNB.
Software fault
To check and try following step:
1. long press push button for 10 seconds, and release the push button, wait HeNB boot up
System resource is overloaded
To check and try following step:
1. long press push button for 10 seconds, and release the push button, wait HeNB boot up
DHCP servers connection failed
To check and try following step:
1. Please check if ethernet cable on HeNB side or uplink router side is loose
2. reboot HeNB
3. reboot uplink router
4. long press push button for 10 seconds, and release the push button, wait HeNB boot up