User's Manual

15/27
All product specifications are subject to change without notice
cells within in rage of each other to the same frequency as this will cause interference as
shown in figure.
6) UL_EARFCN_List – Specify the uplink Radio Frequency Channel Number for two RF card.
7) ULDLMode – Indicates the TDD subframe configuration. The supported values are mode 1
and 2. Specify value 1 will obtain higher uplink bandwidth and lower downbandwidth.
3.1.2.2 Rem Configuration
Algorithm used for handover function. Select band to listen for macro cell for time sync multiple
small cells.
1) REM Enable – Boolean value to toggle function on and off
2) REM Band List – A band that is being broadcast from a microcell in your area which your
small cell can listen to for the time sync function. For example, band 48
3) REM EARFCN – Absolute Radio Frequency Channel Number. Select a list of frequency
Channel numbers that are both supported in your area and by the band that was selected
above. Leaving this section blank will greatly increase the time to find an available Macro
cell. (approximately 2 hours)
Figure 6. Small Cell radiation overlap
Figure 7. REM Configuration
F1 F1 F2 F4 F3
F2 F2 F1 F3 F4
Max
radius:
500 ft.