User's Manual

14/27
All product specifications are subject to change without notice
Small Cell will lack the ability to communicate with configuration/fault management portion the EPC
and must rely on you to manually configuring the device.
1) Ensure that you have reserved a static IP inside of the network with IT and installed all the
necessary software for EPC.
2) Point the Small Cell to the established IP of the EPC. Example IP:
192.168.1.222:8080/femsacs/acs
3.1.2 Advanced Setting
Configure Cell Information, REM Settings and ShareRan settings, Navigate to “One Page Setting -
> Advanced Settings. However, if the basic Settings page has been configured properly this section
should be auto configured by the Auto Configuration Sever (ACS).
3.1.2.1 Cell Configuration
1) Cell Identity – unique identifier to identify Small Cell. Value cannot be assigned to another
2) small cell in the same network
3) TxPowerMax – Maximum power level of the small cell. Sets the LTE max coverage radius.
4) TxPowerMin – Minimum power level of the small cell. Sets the minimum LTE coverage
radius.
5) DL_EARFCN_List – Specify the downlink Radio Frequency Channel Number for two RF
card. In your use case you are using Band 48. This mean the frequency range is from
3550MHz~3700MHz. It is important to note here that you do not want to set multiple small
Figure 5. Basic Configuration Setting