User's Manual

13/27
All product specifications are subject to change without notice
3.1.1 Basic Setting
The Small Cell contains one 10/100mbps Ethernet interfaces. The factory default setting is WAN.
The Ethernet port should be configured according to the actual requirements when used for the first
time. Click “One Page Settings” -> “Basic Settings” to enter the gateway network configuration,
including WAN Configuration and HeMS Configuration.
 WAN Configuration
WAN mode, including two modes --DHCP/ static IP, the specific functions are explained as follows:
1） DHCP: The Small Cell will automatically get the IP address from the superior route, please
contact your IT administrator to get the address. Note: the IP address will be automatically
changed each time the gateway is restarted in this mode.
2） Static IP: the gateway WAN port address should be set by the user. Please contact your IT
administrator for the corresponding information.
a. IP address: enter the IP address information provided by the superior route.
b. Subnet mask: enter the subnet mask provided by the parent route.
c. Gateway: enter the gateway IP address for the superior route.
After confirming that the information input is correct, click the corresponding
application button to change the network configuration.
 HeMS Configuration
The Small Cell has a HeMS configuration function, this function enables the Small Cell to
communicate with Auto Configuration Server (ACS). If you do configure this setting properly your
Figure 4. T99B226 Configuration Overview