ʳʳʳʳʳʳʳʳʳʳʳʳʳʳWIN-A2 WIFI Module User Manual Rev. 0.
Department Name Hardware Engineering GaoJian Confidential Review Dates Plan Results 2
1. Introduction Project Name: 802.11b/g/n WIFI module. This documentation describes the product specification of the WIFI 802.11b/g/n module, it is a confidential document of FOXCONN. 1.1 Scope The device provide communications for applications operating in the globally available 2.4GHz unlicensed ISM band, which utilizing direct sequence spread spectrum and OFDM/CCK technology, the maximum data rate can reach to 65 Mbps(MCS7) for HT20. 1.2 Function ¾ Support single-band IEEE 802.
2. Product Specification 2.1 Output Center And Symbol Clock Frequency Tolerance Center frequency tolerance CH1/CH7/CH13 Spec. (ppm) +/-25 2.2 RF Specification 2.2.1 Spectrum Mask spec Mode of Operation 802.11g 802.11 g at r 9 MHz Offset 802.11 g at r 11 MHz Offset 802.11 g at r 20 MHz Offset 802.11 g at r 30 MHz Offset Mode of Operation 802.11b 802.11b at +/-11MHz~+/-22MHz Offset 802.11b at >+22MHz,<-22MHz Offset Mode of Operation 802.11n-HT20 802.11n at r9 MHz offset 802.11n at r11 MHz offset 802.
2.3 Electrical Specification 2.3.1 Absolute Maximum Ratings The specification indicates levels where permanent damage to the device can occur. Functional operation is not guaranteed under these conditions. Operation at absolute maximum conditions for extended can adversely affect long-term reliability of the device. Rating Symbol Value Unit DC supply voltage for the device VDD -0.5~6 V 2.3.2 Recommended operating condition Parameter Minimum Typical Maximum Unit DC Supply Voltage 3 3.3ʳ 3.
3.
4. Regulatory Information USA-Federal Communications Commission (FCC) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
Canada-Industry Canada (IC) This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device. The term “IC” before the equipment certification number only signifies that the Industry Canada technical specifications were met. Caution: Exposure to Radio Frequency Radiation.
