User's Manual

COMPANY CONFIDENTIAL
11. Regulatory
TBD
12. Environmental Requirements and Specifications
12.1 Temperature
12.1.1 Operating Temperature Conditions
The product shall be capable of continuous reliable operation when
operating in ambient temperature of 0 to +ć 70 .ć
12.1.2 Non-Operating Temperature Conditions
Neither subassemblies shall be damaged nor shall the operational
performance be degraded when restored to the operating temperature when
exposed to storage temperature in the range of -10 to +ć 85ć
.
12.2 Humidity
12.2.1 Operating Humidity Conditions
The product shall be capable of continuous reliable operation when
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two
conditions:
1) this device may not cause interference and
2) this device must accept any interference, including interference that may cause undesired operation of the
device
IMPORTANT NOTE:
IC Radiation Exposure Statement:
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance 20cm between the radiator & your body.
This device is intended only for OEM integrators
under the following conditions:
2/!The antenna must be installed such that 20 cm is maintained between the antenna and users, and
3/!The transmitter module may not be co-located with any other transmitter or antenna,
4/!For all products market in CANADA, OEM has to limit the operation channels in CH1 to CH11 for 2.4GHz
band by supplied firmware programming tool. OEM shall not supply any tool or info to the end-user regarding
to Regulatory Domain change.
A
s long as 3 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements required
with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE: In the event that these conditions can not be met (for example certain laptop
configurations or co-location with another transmitter), then the IC authorization is no longer considered valid
and the IC ID can not be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate IC
authorization.
End Product Labeling
The final end product must be labeled in a visible area with the following: “Contains TX IC : 2878D-
U98Z058”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user regarding how to install o
r
remove this RF module in the user's manual of the end product which integrates this module.
The end user manual shall include all required regulatory information/warning as show in this manual.