COMPANY CONFIDENTIAL U98Z058.02 USB WiFi Module User Manual Rev. 1.
COMPANY CONFIDENTIAL 1. REVISION HISTORY...................................................................................................................................................3 2. INTRODUCTION ..........................................................................................................................................................4 3. PRODUCT SPECIFICATION ..............................................................................................................................
COMPANY CONFIDENTIAL 1. Revision History Date Change Note REV Note 2010-06-17 Initial Release 1.
COMPANY CONFIDENTIAL 2. Introduction Project Name: 802.11 b/g/n wireless card This documentation describes the product specification of the 802.11b/g/n WiFi Module. It is Compliant with IEEE Std 802.11b-1999, IEEE Std 802.11g-2003 and IEEE Std 802.11n-2009. It is a confidential document of Foxconn. 2.1 Scope This 802.11 b/g/n Module is available in the 2.4-GHz ISM band, it is compatible with the IEEE 802.11 b/g standard and the 802.11n standard.
COMPANY CONFIDENTIAL 3. Product Specification 3.1 WiFi RF Specification Wireless LAN Standards IEEE 802.11 b/g/n standard Operating Frequency 2.400 – 2.4835 GHz WLAN Data Rate 802.11g: 54Mbps with fall back of 48, 36, 24, 18, 12, 9, 6Mbps. 802.11b: 11Mbps with fall back rates of 5.5, 2, and 1Mbps 802.11n: Data Rate (MCS0~MSC7) refer to Table A-1 and Table A-2 Modulation Schemes 802.11g: 64QAM (54Mbps, 48Mbps), 16QAM (36Mbps, 24Mbps), QPSK (18Mbps, 12Mbps), BPSK (9Mbps, 6Mbps) 802.
COMPANY CONFIDENTIAL * 40MHz bandwidth is optional for transmit and receive. Transmitter AV Output Power 11b CCK: 17.5+/-1.5 dBm 11g OFDM: 14.0 +1/-2 dBm 11n MCS0~MCS7: 14.0 +1/-2 dBm Receiver Sensitivity Typical -87dBm @11Mbps (PER<8%) Typical -75dBm @54Mbps (PER<10%) Typical -70dBm @MCS7 (PER<10%) 3.2 Electrical Specification Absolute Maximum Ratings These specification indicate levels where permanent damage to the device can occur. Functional operation is not guaranteed under these conditions.
COMPANY CONFIDENTIAL Current Consumption Standby: typically 120mA @3.3V Transmit: 802.11b: typically 320mA @3.3V (Tx Power=17.5dbm) 802.11g: typically 310mA@3.3V (Tx Power=14dbm) 802.11n: typically 315mA@3.3V (Tx Power=14dbm) Receive: typically 220mA @3.3V 4. Product Requirements and Characteristic 4.1 Hardware Characteristic Form factor Host Interface PCB Antenna &RF connector 44.5x40(mm2) module with 2x4 pin connector USB 2.0 4-layer single side Two printed Antenna, with one for diversity. One U.
COMPANY CONFIDENTIAL Top Bottom Figure 2 Board Appearance (For reference) 4.3. Connector information Connector: 2x4P, T/H, Male, Right Angle, 2mm pin pitch. Hirose P/N: DF11-8DP-2DS (52) 4.
COMPANY CONFIDENTIAL Pin No. 1 Pin Name VDD_USB 3 5 7 GND USB_DP WL_REG_ON Description Power supply for the device, 3.3 typically. Ground USB differential positive Enable/disable power the internal regulators Pin No. 2 Pin Name VDD_USB 4 6 8 GND USB_DM GND Description Power supply for the device, 3.3 typically. Ground USB differential negative Ground Notice: WL_REG_ON is used by PMU to enable/disable power the internal regulators, ViH=1.6V, maximum=3.6V. When WL_REG_ON is low (<1.2(1-20%)=0.
COMPANY CONFIDENTIAL ˖ Features 2.4 to 2.
COMPANY CONFIDENTIAL Phi 0 plane cut ant A Phi 90 plane cut ant A
COMPANY CONFIDENTIAL Theta 90 plane cut ant A Phi 0 plane cut ant B
COMPANY CONFIDENTIAL Phi 90 plane cut ant B Theta 90 plane cut ant B
COMPANY CONFIDENTIAL 6. Mechanical Drawing 7.
COMPANY CONFIDENTIAL
COMPANY CONFIDENTIAL 8.
COMPANY CONFIDENTIAL 9. PCB Layout U98Z058.02 PCB is a 4-layer, HDI design, its surface finish is Immersion Silver.
COMPANY CONFIDENTIAL Top Layer Layer 2
COMPANY CONFIDENTIAL Layer 3 Bottom Layer
COMPANY CONFIDENTIAL Top Side Solder Mask Top Side Silk Screen
COMPANY CONFIDENTIAL Top Side Paste Mask Bottom Side Solder Mask
COMPANY CONFIDENTIAL 10. Packing 10.1 Label 10.1.1. MAC ID label: P/N:503.00653.005……1 MAC ID/product Human readable: A.MAC ID:XXXXXXXXXXXX MAC ID Barcode, follow Foxconn standard. C.P/N:U98Z058.02 D.MO: MO-VVSS a. First MO: is letter b. Second MO is Foxconn MO, follow Foxconn standard c. VV: The engineering version d. SS: The version of A300/A400 product Barcode content: XXXXXXXXXXXX MAC ID Barcode, follow Foxconn standard Barcode type: code39, height: 4mm 10.1.2. Carton label: P/N:503.00098.
COMPANY CONFIDENTIAL A.XXXXXXXX: the Foxconn MO B. Qty: XXX XX: The quantity of product in carton Barcode content: The quantity of product in carton C.REV: VVSS VV: The engineering version SS: The version of A300/A400 D.
COMPANY CONFIDENTIAL 10.1.3 Pallet label: P/N:503.00089.
COMPANY CONFIDENTIAL Communication Commission Interference Statement 10.2 AssemblyFederal Drawing & Packing Standard This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
COMPANY CONFIDENTIAL Industry Canada Statement This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: 1) this device may not cause interference and 2) this device must accept any interference, including interference that may cause undesired operation of the device IMPORTANT NOTE: IC Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment.
COMPANY CONFIDENTIAL subjected to relative humidity in the range of 10% and 90% non-condensing. 12.2.2 Non-Operating Humidity conditions The product shall not be damaged nor shall the performance be degraded after exposure to relative humidity ranging from 5% to 95% non-condensing.
