User Manual

DRAFT - CISCO CONFIDENTIAL

Regulatory Compliance and Safety Information for the Cisco 7920 Wireless IP Phone

78-15421-01

Regulatory Compliance

Additional information can also be obtained from the following organizations:

• World Health Organization Internal Commission on Non-Ionizing Radiation Protection at

www.who.int/emf

• United Kingdom, National Radiological Protection Board at www.nrpb.org.uk

• Cellular Telecommunications Association at www.wow-com.com

Manufacturer’s Federal Communications Commission

Declaration of

Conformity Statement

Models: Cisco 7920 Wireless IP Phone

FCC Certification Number: LDK102043

Manufacturer:

Cisco Systems, Inc.

170 West Tasman Drive

San Jose, CA 95134-1706

USA

This device complies with Part 15 rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired

operation.

This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference when the equipment is operated in a residential environment. This equipment generates,

uses,

and radiates radio frequency energy, and if not installed and used in accordance with the

instructions, may cause harmful interference. However, there is no guarantee that interference will not

occur. If this equipment does cause interference to radio or television reception, which can be determined

by turning the equipment off and on, the user is encouraged to correct the interference by one of the

following measures:

• Reorient or relocate the receiving antenna.

• Increase separation between the equipment and receiver.

• Connect the equipment to an outlet on a circuit different from which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician.

Caution The Part 15 radio device operates on a non-interference basis with other devices operating at this

frequency. Any changes or modification to said product not expressly approved by Cisco, including

the

use of non-Cisco antennas, could void the user’s authority to operate this device.