Installation Guide

ManualsBrandsHON HAI Precision Ind ManualsElectronicsPCI-E Embedded Module

TANGOmoduleHWinstallationguide:



1. YoumustturnoffUSB5Vviatheswitch(ie.SW200)andconnect2USBcablestoUSBports(i.eJ300/J204)

ofthecomputerbeforeputtingTANGOmoduleintothetestfixture

2. PluginTANGOmoduleintothetestfixturefromrightsideanduseclapperonthetestfixutertofixthe

TANGO.

3. PutSIMcardintoSIMcardsocketcorrectly .

4. SelectadequateRFadaptorstoconnectRFconnectorinordertodoelectricmeasurement.Thenturn

onUSB5Vviatheswitch

Note:belowistheplacementofeachcomponent



Summary of content (10 pages)

PAGE 1
TANGO module HW installation guide : 1. You must turn off USB5V via the switch(ie.SW200) and connect 2 USB cables to USB ports(i.e J300/J204) of the computer before putting TANGO module into the test fixture 2. Plug in TANGO module into the test fixture from right side and use clapper on the test fixuter to fix the TANGO. 3. Put SIM card into SIM card socket correctly. 4. Select adequate RF adaptors to connect RF connector in order to do electric measurement.
PAGE 2
TANGO module driver user guide : 1. First have HostDrivers (NVIDIA_TANGO_5.45.0455_Release) into your computer. The contents are listed as below : 2. Then click the file name (NVIDIA_TANGO_5.45.0455_Release) to follow its instructions to install until you complete the driver’s installation.
PAGE 3
PAGE 4
3. Put TANGO module into the socket, take out 2 mini‐USB cables to plug in 4. Turn on the switch to let USB 5V input into the fixture.
PAGE 5
Turn off the module if the switch shift toward down. 5. The device management shows 4 unknown COM ports when the switch turn on. You have to follow the indication of the pop‐up window to install adequate drivers.
PAGE 6
5‐1 Please choose the right directory with the TANGO driver for diagnostic port
PAGE 7
5‐2 You can see diagnostic port once you correctly installed. 5‐3 Next driver to be installed is network port. You follow same way to install the driver.
PAGE 8
5‐4 The third driver to be installed is modem port. You follow same way to install the driver. 5‐5 The fourth driver to be installed is AT port. You follow same way to install the driver.
PAGE 9
In conclusion, you can see diagnostic , network , modem , and AT ports in the device management once you succeed.
PAGE 10