User's Manual

Radiation Exposure Statement:
The product comply with the FCC portable RF exposure limit set forth for an
uncontrolled environment and are safe for intended operation as described in this
manual. The further RF exposure reduction can be achieved if the product can be
kept as far as possible from the user body or set the device to lower output power if
such function is available.
This device is intended only for OEM integrators under the following conditions:
1. Antennas must be installed at least 2.5cm away from the user with no any metal
part surrounding the radiating elements to affect the SAR pattern. OEM manufacture
need to confirm SAR compliance if in doubt.
2. Only the identical antennas tested (including the excessive ground plane as shown
in the certification filing) must be sued for portable product. Other antenna(s) even
with the same antenna type and gain will need a class II permissive to verify the SAR
compliance.
3. No co-transmission with other transmitter.
As long as 3 conditions above are met, further transmitter
test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required with this module installed
IMPORTANT NOTE: In the event that these conditions can not be met
(for example
certain laptop configurations or co-location with another transmitter), then the FCC
authorization is no longer considered valid and the FCC ID can not
be used on the
final product. In these circumstances, the OEM integrator will be responsible for
re-evaluating the end product (including the transmitter) and obtaining a separate
FCC authorization.
End Product Labeling
The product can be kept as far as possible from the user body or set the device to
lower output power if such function is available. The final end product must be
labeled in a visible area with the following: “Contains FCC ID: MCLT77W595”. The
grantee's FCC ID can be used only when all FCC compliance requirements are met.
Manual Information To the End User
The OEM integrator has to be aware not to provide information to the end user
regarding how to install or remove this RF module in the user’s manual of the end