User's Manual

COMPANY CONFIDENTIAL
Ambit Microsystems Corporation 國碁電子股份有限公司
中華民國臺灣省新竹縣新竹科學園區新安路 5 5 1
電話886-3-5784975傳真886-3-5782924Internethttp:\\www.ambit.com.tw\
34
Appendix C –Wireless Notices
U.S. Regulatory Wireless Notice
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The FCC requires the user to be notified that any changes or modifications made to device
that are not expressly approved by the Hewlett-Packard Company may void the user's
authority to operate the equipment.
This product emits radio frequency energy, but the radiated output power of this device is far below the
FCC radio frequency exposure limits. Nevertheless, the device should be used in such a manner that
the potential for human contact with the antenna during normal operation is minimized.
!
Warning: Exposure to Radio Frequency Radiation
The radiated output power of this device is far below the FCC radio frequency exposure limits.
Nevertheless, the device should be used in such a manner that the potential for human contact
during normal operation is minimized. In order to avoid the possibility of exceeding the FCC
radio frequency exposure limits, human proximity to the antenna should not be less than 1.5cm
(0.6 inches) during normal operation.
Canadian Regulatory Wireless Notice
Operation is subject to the following two conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
European Union Notice
XXXX
Products bearing the CE marking comply with the R&TTE Directive (1999/5/EC), EMC Directive
(89/336/EEC) and the Low Voltage Directive (73/23/EEC) issued by the Commission of the European
Community.
Compliance with these directives implies conformity to the following European Norms (in parentheses
are the equivalent international standards and regulations):
EN 55022 (CISPR 22) – Electromagnetic Interference
EN55024 (IEC61000-4-2, 3, 4, 5, 6, 8, 11) – Electromagnetic Immunity