User's Manual

PCI Full Rate ADSL Modem Driver Installation
A2RAI-081699
Date Printed: 12/20/99 Page 6 Man_A2.DOC6
2. INSTALLING THE ADSL NETWORK MODEM BOARD
To install the Ambit PCI Full Rate ADSL Modem in your PC and connect it to ADSL
network, follow these steps:
Insert ADSL Network Interface Card – Step 1
1) Open the shipping container and inspect each item for damage.
2) Remove all jewelry from your hands and wrists. Use only insulated or
nonconductive tools.
3) Unplug the PC and disconnect all cables.
4) Remove the PC cover.
5) Choose an empty bus mastering PCI slot.
6) Unscrew the screw holding the PCI slot’s backplate and remove it.
7) Insert the Ambit PCI ADSL Modem into an empty PCI slot.
8) Secure the NIC with the screw you removed earlier.
9) Replace the PC cover and reconnect all previously connected cables.
10) Turn on the power to the PC.
11) Proceed to the next section, “Connecting to the ADSL Network.”
Connect NIC to ADSL Network – Step 2
Connect the telephone cable to the RJ-11 port on the Ambit PCI ADSL Modem.