MIC-B2 WIFI Module User Manual Rev. 0.
Reviewers Review Dates Department Name Plan Results Director of Engineering Hardware Engineering Confidential 2
Table of Contents 1. INTRODUCTION .................................................................................................................................................. 4 1.1 SCOPE .............................................................................................................................................................. 4 1.2 FUNCTION ..............................................................................................................................................
1. Introduction Project Name: 802.11n (5G) 2x2 MIMO WIFI module This documentation describes the product specification of the WIFI 802.11n module, it is a confidential document of FOXCONN. 1.1 Scope The MIC-B2 802.11n module provides wireless modem functionality utilizing OFDM technology. The objective of this use manual is to verify the functionality of the MIC-B2 802.11n module RF/Digital electronic design against the design specifications.
2. Product Specification Absolute Maximum Ratings These specifications indicate levels where permanent damage to the device can occur. Functional operation is not guaranteed under these conditions. Operation at absolute maximum conditions for extended can adversely affect long-term reliability of the device.
3.
4. Regulatory Information USA-Federal Communications Commission (FCC) This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. Caution Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
as below. IC :2878D-MICB2 The proposed with IC No. label format is to be placed on the module. If IC No. is not visible when the module is installed into the system, “Contains IC :2878D-MICB2” shall be placed on the outside of final host system. The term “IC” before the equipment certification number only signifies that the Industry Canada technical specifications were met. Caution: Exposure to Radio Frequency Radiation.
