J20H035 802.
CHAPTER 1 ABOUT THE RF MODULE................................................................ 3 1-1 INTRODUCTION .......................................................................................................... 3 1-2 USING A WIRELESS LOCAL AREA NETWORK.............................................................. 3 1-3 FEATURES AND REQUIREMENTS ................................................................................. 4 CHAPTER 2 MARVELL DRIVER INSTALLATION ...............................
Chapter 1 About the RF Module 1-1 Introduction The RF Module allows you to access Wireless Local Area Networks (WLANs), share a local files with others in your network, access the Internet, and roam about the office—wirelessly. This wireless Local Area Network solution is designed for both large and small businesses, and it is scalable so that you can add users and new network features as your networking needs grow. The RF Module is a WLAN device that allows for access to 2.4GHz WLAN technologies.
1-3 Features and Requirements The RF Module includes the following features: Wireless Features • Support for the IEEE 802.11g standard • Support for the IEEE 802.11b standard • Operates within the 2.4-GHz band • Maximum data rate of up to 54 Mbps (802.11g) • Maximum data rate of up to 11 Mbps (802.11b) Interoperability • WiFi certified at 2.4GHz to ensure wireless interoperability with other WiFi (802.11b) certified devices.
Chapter 2 Marvell Driver Installation 2-1 Marvell Driver Installation 1. Begin installation by finding the new device setup program according to the step described below… 2. Click Next on the Software Setup “find the new device” dialog box.
3. Scan the computer, find the driver in the location of your computer. Figure 2-2 4. Scroll down and check the Box labeled, “Marvell W8100-8385(Bx) 802.
4. Congratulations! Marvell driver has been installed successfully. Please click ‘Finish’ to go to the next step. Figure 2-4 6. The Marvell Driver will automatically be loaded each time your computer started. To access the utility click on Marvell Driver icon in the system tray.
Chapter 3 Marvell Driver Configuration The following sections describe the Marvell Driver. The Marvell Drive provides quick access and friendly interface to configure the Wireless LAN settings. 3-1 Marvell Driver icon The Marvell Driver icon will appear in the system tray each time your card is restarted. Figure 3-1 The Marvell Driver icon will display the current status of the wireless connection. 3-2 Test in the lab 1. Click on the file “DutApiCi8385p.
2. Enter the test program. 3.
Appendix A –Wireless Notices U.S. Regulatory Wireless Notice This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
As long as 3 conditions above are met, further transmitter test will not be required. However, the OEM integrator is still responsible for testing their end-product for any additional compliance requirements required with this module installed (for example, digital device emissions, PC peripheral requirements, etc.).
