User's Manual

J20H018
802.11b/g WLAN Module User Guide
Doc. No. MV-S800245-00 Rev. C
CONFIDENTIAL
Copyright © 2005 Foxconn
Page 38 Document Classification: Proprietary May 26, 2005, 2.00
3.2.3 Profile Setting—Protocol
The protocol tab allows you to set or change the protocol information.
Figure 38: Profile Setting—Protocol Window
DO NOT CHANGE SETTINGS
If this box is checked, the protocol setting is not changed when the profile is applied.
USE BELOW SETTINGS
When the Do not change setting box is unchecked, the protocol settings include:
Table 9: Protocol Window Description
Fields Description
Power Save Mode Sets the power mode. Available options are Continuous Access or Max Power
Save. The default is Continuous Access.
Preamble (802.11b) Sets the Radio Preamble to Auto, short, or Long. This option takes effect only
when attaching to an 802.11b network.
Transmit Rate The range of the data rate depends on the type of AP that the client card is
connected to. The default setting is Auto Select.
Fragment Threshold Sets the fragmentation threshold (the size that packets are fragmented into for
transmission). The default setting is 2346.
RTS/CTS Threshold Sets the packet size at which the AP issues a Request-To-Send (RTS)
or Clear-to-Send (CTS) frame before sending the packet. The default setting
is 2347.
Reset button Resets the protocol settings to their default values.