User's Manual

J20H018
802.11b/g WLAN Module User Guide
Doc. No. MV-S800245-00 Rev. C
CONFIDENTIAL
Copyright © 2005 Foxconn
Page 18 Document Classification: Proprietary May 26, 2005, 2.00
2.4.2 Create Connection with AutoLink AP
To set up a Foxconn wireless client card connection to an existing Foxconn AutoLink AP:
1. Install Foxconn Wireless Adapter (j20H018) on PC. Open device driver and Configuration Utility installation.
2. Launch Configuration Utility.
3. Click "Advanced" tab.
4. Check "Enable Auto Link" and click OK button.
Figure 9: AutoLink AP Connection
5. An AutoLink dialog box opens immediatetly. If not, make sure the "Radio Off" button below the Miscellaneous
box in the utility is unchecked.
6. Select the AP in which to connect, and enter the PIN number used in this AutoLink AP. Click Apply.
Figure 10: AutoLink AP Connection—Security Pin