User's Manual

Safety Precautions for Products with Laser Devices
For information about laser equipment repair, call Customer Care.
If your product is equipped with laser products, it complies with appropriate safety standards, including IEC 60825. With specific regard to the laser, the
equipment complies with laser product performance standards set by government agencies for Class 1 laser products. It does not emit hazardous light; the beam is
totally enclosed during all modes of customer operation and maintenance.
CDRH Regulations
The Center for Devices and Radiological Health (CDRH) of the U.S. Food and Drug Administration implemented regulations for laser products effective August
2, 1976. These regulations apply to laser products manufactured from August 1, 1976, onward. Compliance is mandatory for products marketed in
the United States.
This system is classified as a Class 1 laser product. This label appears on the laser product.
●
Do not
p
lu
g
a modem or tele
p
hone cable into the RJ-45
(
network
)
j
ack.
WARNING!
In addition to the general precautions described earlier in this section, be sure to observe the following precautions when operating a
product equipped with a laser device. Failure to observe these precautions could result in fire, bodily injury, and damage to the
equipment.
WARNING!
Use of controls or adjustments, or performance of procedures other than those specified herein or in the laser product installation guide,
may result in hazardous radiation exposure.