User's Manual

The battery provides power for your HP iPAQ to operate. Your HP iPAQ comes with a HP Smart Connector synchronization cable, which must be used to charge
the device.
It takes approximately 2–4 hours to fully charge the battery for the first time. Subsequent charges might take longer.
Step 4: Turn on your HP iPAQ
Press the
Power
key to turn on your HP iPAQ. Next, follow the instructions on the screen to complete the setup. Use the on-screen keyboard to enter information.
CAUTION:
To avoid damaging your HP iPAQ or the AC adapter, make sure all connectors are properly aligned before connecting.
1. Insert the USB end of the HP Smart Connector s
y
nchronization cable into the
p
ort on the AC ada
p
ter.
2. Connect the AC ada
p
ter to an electrical outlet.
3. Connect the HP Smart Connector synchronization cable to the 24-pin connector on your HP iPAQ. The cable connector fits only one way. If the connector
does not insert easil
y
, turn it over.
TIP:
You can also charge the battery by connecting your HP iPAQ to a USB port on your computer using the HP Smart Connector synchronization
cable. You can also charge the battery by connecting a desktop cradle to the Docking connector on your HP iPAQ.
NOTE:
Whenever a replacement battery is inserted into your HP iPAQ, press the
Power
key for at least two seconds. In case the device does not
turn on, attach the AC adapter to turn on your HP iPAQ.