User's Manual

Find an IP Address
1.
Tap the
(iPAQ Wireless) icon.
2.
Tap the
(WLAN) icon to turn on WLAN.
3. Connect to a network automatically or manually by tapping Start > Settings > Connections >
iPAQ Wireless > WLAN > View WLAN Networks.
4. Select a WLAN network. The WLAN IP Address is shown here.
Delete a wireless network
You can delete networks you manually entered. However, if a network was automatically detected, you
cannot delete it.
To delete an existing or available wireless network:
1.
Tap the
(iPAQ Wireless) icon.
2.
Tap the
(WLAN) icon to turn on WLAN.
3. Tap WLAN > View WLAN Networks > Wireless.
4. In the Configure Wireless Networks box, tap and hold the network you want to delete.
5. Tap Remove Settings.
Configure the 802.1x authentication settings
Before performing these steps, determine if authentication information is needed by contacting your
network administrator.
1. To manually enter information, tap Start > Settings > Connections > iPAQ Wireless > WLAN >
View WLAN Networks.
2. In Wireless networks list, select the network you want to configure.
3. For increased security, select the Use IEEE 802.1x network access control check box. Then,
select the appropriate EAP type.
Bluetooth
Bluetooth terms
It is recommended that you become familiar with the following terms as you begin to use Bluetooth
technology.
Term Definition
Authentication Verification of a numeric passkey before a connection or activity can be completed.
Authorization Approval of a connection, access, or activity before it can be completed.
20 Chapter 6 Connections