User Manual

7
Cisco Edge 300 Series Switch Installation Guide
OL-24909-01
Installing the Switch
Warning Statements
Statement 1005
Warning This product relies on the building’s installation for short-circuit (overcurrent) protection. Ensure that
the protective device is rated not greater than:
20A Statement 1005
Statement 1071
Statement 1019
Warning The plug-socket combination must be accessible at all times, because it serves as the main
disconnecting device. Statement 1019
Statement 1030
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Statement 1040
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Statement 1044
Warning For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection:
10/100/1000 Ethernet Statement 1044
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this
device.
Statement 1071
SAVE THESE INSTRUCTIONS