User's Manual

31
Appendix C Wireless Notices
U.S. Regulatory Wireless Notice
This device complies with Part 15 of the FCC Rules. This product emits radio frequency
energy, but the radiated output power of this device is far below the FCC radio frequency
exposure limits. Nevertheless, the device should be used in such a manner that the potential
for human contact with the antenna during normal operation is minimized.
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users. For
laptop installations, the antenna must be installed to ensure that the proper spacing is maintained in the
event the users places the device in their lap during use (i.e. positioning of antennas must be placed in
the upper portion of the LCD panel only to ensure 20 cm will be maintained if the user places the
device in their lap for use) and
2) The transmitter module may not be co-located with any other transmitter or antenna.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be installed such
that 20 cm may be maintained between the antenna and users (for example access points, routers,
wireless ASDL modems, certain laptop configurations, and similar equipment).
The final end product must be labeled in a visible area with the following: " FCC ID:
MPI350-U58H004"
Additional Information That Must be Provided to OEM Integrators
The end user should NOT be provided any instructions on how to remove or install the device.
USA Radio Frequency Interference Requirements
FCC Regulations Part 15 Declaration of Conformity (DoC)
Ambit Microsystems Corporation declares that the equipment described in this document is within the
requirements of the Code of Federal Regulations listed below:
Title 47 Part 15, Subpart B, Class B for a digital device.
This declaration is based upon the compliance of the Wireless LAN Mini PCI Adapters to the above
standards. Ambit has determined that the models listed have been shown to comply with the applicable
technical standards if no unauthorized change is made in the equipment and if the equipment is
properly maintained and operated.
These units are identical to the units tested and found acceptable with the applicable standards. Records
maintained by Ambit continue to reflect that units being produced under this Declaration of Conformity,
within the variation that can be expected due to quantity production and tested on a statistical basis,
continue to comply with the applicable technical standards.